Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Lakewood, CA
Gate access control in Lakewood usually costs between $850 and $3,200 depending on whether you’re adding a keypad to an existing opener or replacing a full video-intercom system. Lakewood’s 1950s tract homes were built with narrow side-yard gates and original wrought iron that’s now 70 years old, so most jobs involve working around corroded posts and uniform lot layouts rather than just swapping a circuit board. Call (657) 271-2877 and a live person answers at any hour.
Why Lakewood Homes Are Different
Lakewood was built almost entirely between 1950 and 1954 as one of America’s first large-scale master-planned communities. That means nearly every residential gate in the city is the same age, and the original concrete gate-post footings are cracking, tilting, and heaving at roughly the same rate city-wide. Technicians see the same 1950s post-base failures on street after street, not sporadically, which makes post re-setting a near-universal part of gate repair calls here.
The homes themselves are single-family tract houses built to a handful of nearly identical floor plans, so gate widths, post placements, and side-yard clearances are remarkably uniform. Original ornamental wrought iron side gates and galvanized chain-link rear gates from the early 1950s are still common on properties that have never had a full replacement. But Lakewood sits close enough to the Port of Long Beach that marine-layer moisture and salt-laden air reach the city year-round, and iron and steel gates that might last 20 years inland are often heavily corroded in 12 to 15 years here. Hinges, latches, and hollow steel frames take the worst of it.
Our Main Lakewood Services
These are the three services Lakewood homeowners call us about most often, and each has its own dedicated Lakewood page with full pricing and detail.
Gate Repair in Lakewood
Most repair calls in Lakewood start with a gate that won’t close fully or a hinge that’s sagging under 70-year-old wrought iron. We work on the gate that’s already on the property, whether it’s an original 1950s ornamental side gate or a newer steel driveway gate, and every repair gets a written price before work starts. See the full scope at Gate Repair in Lakewood.
Gate Installation in Lakewood
Because Lakewood’s housing stock was built all at once, full gate replacement rather than patchwork repair is unusually common here. The original 1950s gates are reaching end-of-life simultaneously, and new installations often mean re-setting the original concrete footings as well. Details on materials, lead times, and the written scope of work are on the Gate Installation in Lakewood page.
Gate Motor & Opener in Lakewood
Salt-laden air from the port accelerates corrosion on motor housings and limit switches faster than homeowners expect, and we service nine major automation brands rather than steering you toward a replacement. Whether it’s a swing-arm opener or a slide-gate motor, the flat price is written and handed over before any work starts. Full brand list and pricing at Gate Motor & Opener in Lakewood.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterGate Access Control in Lakewood
Gate access control in Lakewood means adding the electronics that let someone in without getting out of the car: keypads, remotes, phone entry, card readers, or video intercoms. Because Lakewood’s tract homes were built in a single burst between 1950 and 1954, the original side gates and concrete posts are all aging at once, and most access-control jobs here start with checking whether the existing post can still hold a keypad or reader before any wiring begins. Our full Gate Access Control service covers every brand and configuration, with a written price before any tool is picked up.
Keypad Entry
Signs you need it
The gate works manually but you want code-based entry for family, deliveries, or a tenant without handing out remotes.
What it costs in Lakewood
A new keypad entry system in Lakewood typically runs $850 to $1,950 installed, depending on whether it ties into an existing opener or needs a standalone controller.
How we do it
We mount the keypad on a solid post or column, run the low-voltage wiring to the opener’s control board, program your codes, and photograph every connection before we leave.
Video Intercom
Signs you need it
You want to see and talk to whoever is at the gate before opening it, from inside the house or from a phone app.
What it costs in Lakewood
Video intercom systems in Lakewood typically cost $1,800 to $3,200 installed, with the higher end including a camera, interior monitor, and app-based remote access.
How we do it
We install the camera unit at the gate, run cabling to an interior monitor or network bridge, configure the app, and hand you a written record of every setting.
What Gate Access Control Costs in Lakewood
| Item | Typical range in Lakewood |
|---|---|
| Keypad entry (new install) | $850 - $1,950 |
| Video intercom (full system) | $1,800 - $3,200 |
| Remote control add-on | $75 - $300 |
Can you add a keypad to my existing Lakewood gate opener?
In most cases, yes. We check the opener’s control board for a compatible input and the post condition first. If the existing post is corroded or leaning, we may need to re-set it before mounting the keypad. Call (657) 271-2877 for a written answer on your specific setup.
Does marine air in Lakewood affect access-control wiring?
Yes. Salt-laden air accelerates corrosion on exposed low-voltage connections and terminal blocks. We use weather-sealed enclosures and dielectric grease on all Lakewood outdoor connections, and we photograph the final wiring so future service doesn’t start from scratch.
Gate Parts & Welding in Lakewood
Gate parts and welding in Lakewood usually means the original 1950s ironwork has finally failed: hinges snapped, posts heaving, or a weld cracked on an ornamental side gate. Because Lakewood’s entire housing stock was built at the same time, these failures appear city-wide in clusters rather than randomly, and the salt-laden air from the Port of Long Beach accelerates the rust that causes them. Our Gate Parts & Welding service covers replacement parts, on-site welding, and full post re-setting with a documented photo record on every visit.
Hinge Replacement
Signs you need it
The gate drags on the ground or the hinge pin area shows heavy rust bloom and the gate no longer swings level.
What it costs in Lakewood
Hinge replacement in Lakewood typically runs $260 to $490 per hinge, depending on whether the hinge is surface-mounted or requires cutting and re-welding.
How we do it
We cut or unbolt the failed hinge, grind the post surface clean, weld or bolt the new hinge in place, and re-hang the gate to swing level.
Post Replacement
Signs you need it
The gate post leans visibly, the concrete footing is cracked, or the post has rusted through at the base where it meets the ground.
What it costs in Lakewood
Post replacement in Lakewood typically costs $550 to $1,100 per post, including digging out the old footing, setting a new post in concrete, and re-hanging the gate.
How we do it
We remove the old post and footing concrete, set a new steel post plumb in fresh concrete, brace it while it cures, then re-mount the gate and any hardware.
What Gate Parts & Welding Costs in Lakewood
| Item | Typical range in Lakewood |
|---|---|
| Hinge replacement (per hinge) | $260 - $490 |
| Post replacement (per post) | $550 - $1,100 |
| Custom welding (per hour on-site) | $120 - $180 |
Can you weld my original 1950s wrought iron gate in Lakewood without replacing it?
Often yes. If the surrounding metal is still structurally sound, we can grind back the rust, weld in a repair section, and repaint. If the frame is severely pitted from decades of marine air, replacement may be the cheaper long-term option. We’ll give you a written price for both before any work starts.
Why are gate posts failing all over Lakewood at the same time?
Lakewood’s tract homes were all built between 1950 and 1954 on similar soil, so the original concrete footings are the same age and have weathered at roughly the same rate. When we replace one post on a Lakewood street, we often find neighboring properties have the same cracking, tilting, and heaving.
Brands We Service in Lakewood
We service Linear, Viking, Ghost Controls, and DoorKing opener and access-control systems in Lakewood, and our local stock covers common control boards, remote receivers, and safety-edge parts for these brands. See our brands for the full list.
Pricing for Gate Repair in Lakewood, CA
| Service | Typical range in Lakewood |
|---|---|
| Gate repair (per hour on-site) | $110 - $140 |
| Gate installation (full new gate) | $1,900 - $7,500 |
| Gate motor replacement (swing) | $1,000 - $2,500 |
| Gate motor replacement (slide) | $1,200 - $3,000 |
| Keypad entry (new install) | $850 - $1,950 |
| Video intercom (full system) | $1,800 - $3,200 |
| Hinge replacement (per hinge) | $260 - $490 |
| Post replacement (per post) | $550 - $1,100 |
| Custom welding (per hour on-site) | $120 - $180 |
| Gate roller replacement | $180 - $420 |
Prices in Lakewood push higher when a 70-year-old post needs re-setting before new hardware can be mounted, or when salt corrosion has spread into the opener’s control board and motor housing. Whatever the scope, the flat price is written and handed to you before any work starts, and it’s the price you pay at the end.
Neighborhoods We Serve in Lakewood
We cover every residential neighborhood in Lakewood, including the original 1950s tract areas where gate post failures are most common. Our typical response time for gate repair calls in Lakewood is same-day or next-day, and 24/7 for emergency gate failures.
- Lakewood Mutual Manor
- Mayfair
- Lakewood Park
- East Lakewood
- Candlewood
Service Area - Cities Near Lakewood
We also provide gate repair and access-control service to neighboring cities around Lakewood, including Long Beach, CA, Seal Beach, CA, Los Alamitos, CA, and Cerritos, CA. Dispatch and scheduling are coordinated from the brand’s Los Angeles office, and crews serve Lakewood locally.
Serving Lakewood, CA - Our Local Coverage Area
We’re based in the Lakewood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Lakewood
We aim for same-day response on most Lakewood gate failures and maintain 24/7 emergency availability. A live person answers the phone at any hour, not a voicemail loop. Call (657) 271-2877 and tell us what the gate is doing; we’ll give you a straight answer on arrival time.
Most residential gate repairs and like-for-like replacements in Lakewood don’t require a city permit, but any installation that changes the driveway width or adds an automatic opener may trigger review. We’ll check the current Lakewood requirements on your specific project and tell you what applies in writing.
Yes. We service gates and openers from any manufacturer and any prior installer. If you have another company’s written estimate, we’ll review it at no cost as a free second opinion. The price we quote is written and handed to you before any work begins.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lakewood Customers Say
"Quoted in writing, installed on the day promised, and the price did not move. The crew was licensed and the number was on the paperwork."
- Wes A."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H."They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C.